Makita po5000c users

T

tucko

New member
Joined
Aug 30, 2012
Messages
10
Reaction score
0
HI guys I have a question, what kind of pads are you guys using on your makita po5000c, as always, thank you in advance..
 
I'll share what I've used....

Any 5.5" foam pad


6 inch Buff and Shine Uro-Cell Pads

6 Inch Buff & Shine Uro-Tec Foam Pads

Lake Country HDO 5.5 Inch Foam Pads

Lake Country 5.5 inch SDO Pads


I don't remember using the Hybrid pads on this tool but they should work just fine.

Lake Country Hybrid Power Finish 5 Inch Foam Pads



The thing about any gear-driven orbital is because it's a direct drive tool it will turn and churn any pad. Thicker pads, especially when it comes to stiffer foam cutting pads, will fell smoother to your hands than thinner pads but these types of tools really don't care what type of pad you put on it.... it's going to spin.



:buffing:
 
Thank you very much Mr. Mike Phillips and Mike Shine Struck..
 
Lake Country Hybrid Pads here on my Makita and I love it.
 
I use the new Lake Country 7/8” CCS pads, Lake Country ThinPro’s and Buff and Shine Uro’s

ScottH
 
My new po5000c should be here tomorrow. Retiring my trusty old pc7424 to 3" pads only. I also use LC ccs pads so that's what I will continue to use with the makitia. Hope the makitia is as good as all the reviews.
 
Rambro can you post a review of the makita po5000c I want to pull the trigger on that buffer too...
 
Hi tucko. I got my makitia today and will be using it tomorrow if the rain holds off. I will post a review once I use it. It is a little heavier than the PC but it is a nice looking tool.
 
You must log in or register to reply here.
Back
Top