builthatch
01-10-2009, 07:21 PM
i'm stepping up to a rotary after a year with my PC.
as with my PC, i'm only going to use foam 5.5" and 4" pads.
my current stash is yellow, orange, white and green. mostly all CCS, all following the same color code (yellow hardest --> red softest order)
i rarely used yellow for anything other than incredible problem areas, i used mostly orange and white, while finishing with green and poli-seal. i say used because i know with the rotary i'll not need as much mechanical help as before, meaning my yellow pads will probably be totally out of the picture now.
i use all optimum products and i apply LSP by hand, which typically is opti-seal.
so, considering the power of the rotary, which should i pick to supplement my current pad selection?
step up to a finer CCS finishing pad (gray) as opposed to the green, get a red pad for final burnishing? both?
thx
as with my PC, i'm only going to use foam 5.5" and 4" pads.
my current stash is yellow, orange, white and green. mostly all CCS, all following the same color code (yellow hardest --> red softest order)
i rarely used yellow for anything other than incredible problem areas, i used mostly orange and white, while finishing with green and poli-seal. i say used because i know with the rotary i'll not need as much mechanical help as before, meaning my yellow pads will probably be totally out of the picture now.
i use all optimum products and i apply LSP by hand, which typically is opti-seal.
so, considering the power of the rotary, which should i pick to supplement my current pad selection?
step up to a finer CCS finishing pad (gray) as opposed to the green, get a red pad for final burnishing? both?
thx