Critique tomorrow's detail process

F

fly4food84

New member
Joined
Aug 24, 2008
Messages
15
Reaction score
0
Tomorrow is part #1 of the big detail.

I'm planning to do the following:

Wash, Clay, Poorboys SSR2 (PC set on 4.5 with polishing pad), Klasse AIO (PC set on 3 with finishing pad). Wait 24 hrs... Poorboys EX, Wait 24 hrs... Adam's Americana.
 
I think you should use the PC at speed 5 minimum with sufficient pressure (10+ lbs) to break down SSR2 properly.
 
Also, your process should be created according to what it's going to take to correct the defects unless you're doing a 1-step process regardless of whether the defects in the clear are being removed or not.

Every car will be different, so do a small test section with a couple of different approaches before you actually set a correction process for a vehicle.
 
O.C.Detailing said:
...do a small test section with a couple of different approaches before you actually set a correction process for a vehicle.
Click to expand...

:iagree: Don't just formulate what seems like a good idea in your head and go do it to the whole car, do a small test section. If it gives you what you want then go with it if not try something new till your happy and duplicate that process on the rest of the car. :dblthumb2:
 
fly4food84 said:
Tomorrow is part #1 of the big detail.

I'm planning to do the following:

Wash, Clay, Poorboys SSR2 (PC set on 4.5 with polishing pad), Klasse AIO (PC set on 3 with finishing pad). Wait 24 hrs... Poorboys EX, Wait 24 hrs... Adam's Americana.
Click to expand...

How did it go?


:)
 
A4 1.8tqm said:
do a small test section. If it gives you what you want then go with it if not try something new till your happy and duplicate that process on the rest of the car. :dblthumb2:
Click to expand...

That's one of the best ways to insure success...


:xyxthumbs:
 
You must log in or register to reply here.
Back
Top