TeddyKGB
06-26-2010, 10:14 PM
So I did some reading last night on using the Klasse SG product and thought I read that if I ran into some tough spots when removing it I could just spritz with water.
My process was to use a small MF pad to apply to 1 or 2 panels at a time. Let drive for 10-15 min (its hot out) and buff out with a clean dry MF towle. I was typically able to get most of it off but had stubborn areas so I spritzed with plain water and wiped it dry.
Now I come in for the night and just do some more reading and I came across a few posts that say NOT to spritz with water. I was planning on doing a second coat late tomorrow morning either way.
What did I do? Did I just spend an hour+ sweating outside for nothing?
Feed back please
My process was to use a small MF pad to apply to 1 or 2 panels at a time. Let drive for 10-15 min (its hot out) and buff out with a clean dry MF towle. I was typically able to get most of it off but had stubborn areas so I spritzed with plain water and wiped it dry.
Now I come in for the night and just do some more reading and I came across a few posts that say NOT to spritz with water. I was planning on doing a second coat late tomorrow morning either way.
What did I do? Did I just spend an hour+ sweating outside for nothing?
Feed back please