New use for DG105

[Old Tiger]

I removed the Made in Louisville, KY sticker from the Ford today. The adhesive that stuck to the windshield was ornery to remove. I tried Megs Body Solvent but realized it would take a lot of time. I had OPC but decided to try an AIO. I had DG 105 and DG501. I started with the less aggressive 105. That was all that was needed. Took the adhesive off the inside windshield in no time with no elbow grease. I was going to get the 3M Adhesive, but it couldnt be much easier than the DG105. I dont think I need the 3M now!

[sydster]

Thanks for sharing! :xyxthumbs:

[dougaross]

Good to know. I probably would gotten out the Goo Gone.

[mg6045]

The 3m should still have a place in your arsenal imo.

There are some area's where you do not want to do ANY rubbing at all, because of the risk of scratching.

for these area's the 3m is what is needed IME. spray on, rinse off. than re-application, and wipe off.

[Old Tiger]

Good to know. I probably would gotten out the Goo Gone.
Funny you should say that! Mrs. Old Tiger was looking for it in its proper place and couldnt find it! That was my second choice after 3M which I didnt have.

[Old Tiger]

The 3m should still have a place in your arsenal imo.

There are some area's where you do not want to do ANY rubbing at all, because of the risk of scratching.

for these area's the 3m is what is needed IME. spray on, rinse off. than re-application, and wipe off.

I agree! If I was removing an emblem or something. I didnt apply any elbow grease with the 105. I was surprised at how well it worked.

[BobbyG]

Good information Jim, that's for letting us know...:props:

[Old Tiger]

Bobby, anytime I find a trick you dont know, I feel like I did something! You have taught me a ton!