mwtaco
12-20-2011, 08:07 PM
I used a white LC CCS pad to apply Duragloss 501 on my car today.
I sprayed XMT PPC on the pad afterwards to clean it. I let it sit for 10 minutes, scrubbed with a brush and rinsed. Still lots of product oozing out when i wring it. I repeated 2 more times. Still lots of product in the pad.
At this point, I sprayed it again and will let it sit over night.
Was expecting something quicker/easier to use. I don't expect it to be white again, but I thought it would dissolve the product inside.
I could let it soak overnight in solvent, but that would defeat the whole point of the XMT PPC spray. I could do that with any of the APC or Dawn that I already had.
I am open to the possibility that I am approaching this incorrectly and welcome any suggestions.
Thanks.
Before:
http://www.autogeekonline.net/gallery/data/500/medium/IMG_03771.JPG
After (soaking with XMT):
http://www.autogeekonline.net/gallery/data/500/medium/IMG_21423.jpg
I sprayed XMT PPC on the pad afterwards to clean it. I let it sit for 10 minutes, scrubbed with a brush and rinsed. Still lots of product oozing out when i wring it. I repeated 2 more times. Still lots of product in the pad.
At this point, I sprayed it again and will let it sit over night.
Was expecting something quicker/easier to use. I don't expect it to be white again, but I thought it would dissolve the product inside.
I could let it soak overnight in solvent, but that would defeat the whole point of the XMT PPC spray. I could do that with any of the APC or Dawn that I already had.
I am open to the possibility that I am approaching this incorrectly and welcome any suggestions.
Thanks.
Before:
http://www.autogeekonline.net/gallery/data/500/medium/IMG_03771.JPG
After (soaking with XMT):
http://www.autogeekonline.net/gallery/data/500/medium/IMG_21423.jpg