Bostonbull
New member
- Jun 7, 2012
- 28
- 0
I knew I had a machine somewhere from when i was in high school, learning to detail cars at a used car lot. I found it today, a Black and Decker "buffmaster" model 6138.
I am not sure if this machine is any good for use, it hasnt been talked about on forums for a few years, and apparantly has gone through several transformations and is now sold under the Dewalt name?
I would love to teach myself how to properly use this machine, and make my cars that much nicer.
Where do I start, should I even mess around with 2 brand new cars being all I have to learn on? What should I start with for products?
Are there any articles out there with discussion in things like
I am sure this has been covered, but with 1-3 pages of new entries everyday, searching is a bit tough, this forum has so much information to decipher!
I am not sure if this machine is any good for use, it hasnt been talked about on forums for a few years, and apparantly has gone through several transformations and is now sold under the Dewalt name?
I would love to teach myself how to properly use this machine, and make my cars that much nicer.
Where do I start, should I even mess around with 2 brand new cars being all I have to learn on? What should I start with for products?
Are there any articles out there with discussion in things like
- Speed
- Pads
- Products
- Using it machines around trim and weather stripping
I am sure this has been covered, but with 1-3 pages of new entries everyday, searching is a bit tough, this forum has so much information to decipher!