ShineTimeDetail
08-23-2012, 10:00 AM
Made a little video showing a 3 step process on a F150. 2 steps on a rotary and final step with the flex 3401. I start out at about 1000-1100 then kick it up to 2000 rpm(Personal preference) Then finish around 12-1500.
I seriously probably could've gone from yellow pad to white pad but I figured I'd throw an extra step in there.
I don't know if its my computer I'm on right now but the picture is bad. The computer I used to edit the video seemed much better quality before it was uploaded to YouTube.
[ame=http://www.youtube.com/watch?v=6M-UZ0srBX0]Shine Time Mobile Auto Detail St. Louis Clay Bar/ Polishing with a Rotary to a Hologram Free Finish! - YouTube[/video]
I seriously probably could've gone from yellow pad to white pad but I figured I'd throw an extra step in there.
I don't know if its my computer I'm on right now but the picture is bad. The computer I used to edit the video seemed much better quality before it was uploaded to YouTube.
[ame=http://www.youtube.com/watch?v=6M-UZ0srBX0]Shine Time Mobile Auto Detail St. Louis Clay Bar/ Polishing with a Rotary to a Hologram Free Finish! - YouTube[/video]