Radster1986
New member
- Oct 19, 2012
- 63
- 0
After my rather unpleasant experience with the window tinter, who at this point I am washing my hands of and dont care to deal with them any further for any reason. I would like some advice on how to correct a few boo boos they inflicted on my car and nothing serious that I can see at this point, but heres the deal...
I have the car coated with CQuartz Finest, which is awesome and I just had some stuff touched up by my detailer who is an awesome dude, to have the window tinter guys rub all up on the car and leave rub marks and swirl marks, and some cute little lines on the back spoiler where they cut the tint film. My question is...
How can I straighten out the swirls and rub marks in the coating without damaging/removing the coating, I was told using a little Ultimate Polish is ok as long as I go about it lightly and dont get too over zealous on rubbing it out.
How can I straighten out that fine scratch, again without messing with the coating ( less important in the respect because of where it is)
Regardless these issues can be fixed, its just annoying I have to do it now when I shouldn't have to. I just want to make sure I go about it the right way as to not to disturb the effectiveness of the CQuartz.
I have the car coated with CQuartz Finest, which is awesome and I just had some stuff touched up by my detailer who is an awesome dude, to have the window tinter guys rub all up on the car and leave rub marks and swirl marks, and some cute little lines on the back spoiler where they cut the tint film. My question is...
How can I straighten out the swirls and rub marks in the coating without damaging/removing the coating, I was told using a little Ultimate Polish is ok as long as I go about it lightly and dont get too over zealous on rubbing it out.
How can I straighten out that fine scratch, again without messing with the coating ( less important in the respect because of where it is)
Regardless these issues can be fixed, its just annoying I have to do it now when I shouldn't have to. I just want to make sure I go about it the right way as to not to disturb the effectiveness of the CQuartz.