Old Tiger
New member
- Oct 27, 2009
- 4,468
- 0
These pads are very good but the linting off of a new pad is UNSAT! Even blowing with compressed air before initial use doesnt make them SAT! I took all of my new pads and washed them with a double rinse. Then after washing, I found another use for my 8 HP Metro Master Blaster. The two motors provide a lot of heat. The hot air dried and fluffed them up very nicely.
I havent had to prewash Megs or Optimum MF pads. I shouldnt need to do it for LC MF pads either! Eric IMO you need to solve this linting problem in the factory. There is too much good competition, especially with the new Buff & Shine MF pads, which I have on the way!
hese are fine pads once the loose fibers are all removed!
Eric please fix this issue!
I havent had to prewash Megs or Optimum MF pads. I shouldnt need to do it for LC MF pads either! Eric IMO you need to solve this linting problem in the factory. There is too much good competition, especially with the new Buff & Shine MF pads, which I have on the way!
hese are fine pads once the loose fibers are all removed!
Eric please fix this issue!