View Full Version : Paint Correction for "A" "B" Pillar and Narrow Surfaces?
CharlieSheen
07-07-2013, 11:38 AM
What advice do you guys have for these areas that are narrow and have a lot of edges?How are you polishing with the DA?
theblob640
07-07-2013, 11:59 AM
Tape off what ever does not need polishing. Attach a 3" or 3.5" backing plate with 4" pads and make some noise.
cleanmycorolla
07-07-2013, 12:40 PM
Tape off what ever does not need polishing. Attach a 3" or 3.5" backing plate with 4" pads and make some noise.
:iagree:
ShinyRex
07-07-2013, 12:45 PM
3" hydrotech pads
Evan.J
07-07-2013, 12:52 PM
:iagree:
3" hydrotech pads
Both of these!
DetailedByPrecision
07-07-2013, 03:51 PM
I prefer 3'' pads for better control, and edging.
Kyle@PrecisionPolish
07-07-2013, 05:14 PM
Lake Country has the 3 inch pads? I just looked and couldn't find them. Which type of pad comes in the 3 inch?
Kyle@PrecisionPolish
07-07-2013, 05:15 PM
Nevermind I just read it wrong. Your talking about the 3 x 1.25 pads correct?
Your using the LC 3 inch backing plate?
Evan.J
07-07-2013, 05:19 PM
Yep 3x1.25 is what you want with the 3" backing plate. The hydrotechs are great pads
nissenc1337
07-07-2013, 09:24 PM
Is there a 3" backing plate for the Flex 3401? Everyone mentions the 4"
WRAPT C5Z06
07-07-2013, 11:12 PM
Is there a 3" backing plate for the Flex 3401?
No, 4" is the smallest.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.