View Full Version : speaker grills
James,
10-01-2013, 02:31 AM
How do you clean speaker grills ?
oldmodman
10-01-2013, 03:23 AM
I usually use a toothbrush to loosen the dirt and then a vacuum with a brush attachment to suck it out before it can fall into the cone.
I don't use any liquid spray on cleaners since they can go right through the grill and destroy both the speaker surround and the cone itself.
imranhakro
10-01-2013, 04:46 AM
Open speaker grills,
Clean with diluted APC using toothbrush,
Apply dressing after drying it,
Screw back into the speakers.
James,
10-01-2013, 05:02 AM
steam would be the trick but i dont have a vapor one
PA DETAILER
10-01-2013, 09:34 AM
soft brush. can compressed air.
kb2ehj
10-01-2013, 09:45 AM
steam would be the trick but i dont have a vapor one
Probably not actually.......the water I suspect would damage the speaker cone.
James,
10-01-2013, 09:52 AM
I think ill try a booth polishing brush with a mist of apc
kb2ehj
10-01-2013, 09:57 AM
I think ill try a booth polishing brush with a mist of apc
I think that is the safest way to go. Your results should be very good.
Post some before/after pictures and a write up on your technique. That will help others that might have the same question.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.