kevincwelch
New member
- May 12, 2013
- 2,686
- 0
I've noticed a few areas around the door handles on my car that are a bit swirled up. They're on the passenger's side (wife, kid).
At this point, they're not bad enough for me to really worry about them -- yet. (The winter's been long!).
The car already has C1 and EXOv2 on it.
If I needed to polish these defects, would you just polish a small section and then reapply C1 and EXOv2 or would you recommend polishing the panel out so that it's even when you reapply C1 and EXOv2? (I know EXOv2 can be topped, but I wonder about C1 over EXOv2 and mixing the layers.)
At this point, they're not bad enough for me to really worry about them -- yet. (The winter's been long!).
The car already has C1 and EXOv2 on it.
If I needed to polish these defects, would you just polish a small section and then reapply C1 and EXOv2 or would you recommend polishing the panel out so that it's even when you reapply C1 and EXOv2? (I know EXOv2 can be topped, but I wonder about C1 over EXOv2 and mixing the layers.)
