I received my GG6, LC 5.5" backing plate, HD speed, and LC thinpro pads a couple days ago and got to use it today! First time ever touching a polisher so I started with an orange pad and set the machine to 4.
I did about half of the truck and never thought to change the pad seemed like it was not thickened up with Polish or anything and then I decided to change pads and when I went to pull it off the middle was completely melted out of it? Is this my fault a faulty pad did I run the machine to long? Are you supposed to stop and let the machine rest ever so often? Didn't seem like it was getting hot or anything! And how much correction can I expect from a product like speed? My truck is shiny as ever as seen in the truck selfie and a lot of small scratches are gone but some still exist.
View attachment 39326View attachment 39325
I did about half of the truck and never thought to change the pad seemed like it was not thickened up with Polish or anything and then I decided to change pads and when I went to pull it off the middle was completely melted out of it? Is this my fault a faulty pad did I run the machine to long? Are you supposed to stop and let the machine rest ever so often? Didn't seem like it was getting hot or anything! And how much correction can I expect from a product like speed? My truck is shiny as ever as seen in the truck selfie and a lot of small scratches are gone but some still exist.
View attachment 39326View attachment 39325