Recent content by Atticus808

bump would love to have more likes! thank you in advance:)

thank you guys! really means a lot! if anyone else can also help like the photo I would appreciate it!

bump. would really appreciate the help! :)

I'm in a competition for a local detailing shop and the picture with the most likes gets the win! the winner wins a Metro Master Blaster! I don't have that in my tools so I would love to have it. PLEASE help a fellow detailer out and click on the below Facebook link and like the picture...

i just called and they said they will replace it without any question. great place!

does it make a difference if it's a piece of grass? it looks like it anyway. about about 3-4 mm. it's on the top of the fender

another pic

just got PPF put on and when I got home I noticed this. i know PPF won't be 100% though

I did clay off like maybe 60% off the top of the roof. and there might be some above my rear wheel wells. another forum recommended IPA. what are your thoughts? just trying to gather as much info before I go out tomorrow to do it

and thanks for all the suggestions! I have einszett bug and tar remover. would that work?

hey! the whole thing is not really sticky I guess, more of a line where you can tell the sheets were. when I spray water all over the car I notice that the areas covered in the sheets, the water beads off?

I got a new car and I didn't want the dealership to touch my car with any brushes or towels, but have them remove that white protective sticky sheet. but now there's some left over stickiness. I tried clay and got some of it off tried APC and didn't really do much tried griots adhesive remover...

nope. didn't prime it. I read here you don't have to prime Rupes pad, but that's with the Rupes system. I use the foam pads with menzerna without priming though and it works great. I'll try a squeeze of spray wax next time

no compressed air. i should have bought the blue foam pads for cut!

used it for the first time the other day. the fibres seem to lay down quickly and it's very difficult for me to fluff them back up compared to other cutting pads. anyone else have any tips for them? i should mention that the results came out great though (4", used 3 drops of menzerna fg400)