Recent content by bigmackmiller

I’ll give 205 and orange a try and see if I can get anywhere Sent from my iPhone using Tapatalk

Anyone have a good combo for them? I’ve tried Griots D/A with VSS/orange pad, M205/white pad, M105/ Microfiber medium cut pad followed by the m205 combo all with similar results, looks about the same on the other side but did not polish it Sent from my iPhone using Tapatalk

Maybe it is a factory flaw then with the truck being from a similar era @ GM, and or clear coat etching from age. This truck is a 2001 Chevrolet 2500HD, to my knowledge the hood, and bedsides are the only repainted areas. I too am seeing this on the horizontal surfaces. The pic was taken on...

Not to my knowledge, the good has been repainted and the bed sides were repaired, but this was on the top of the cab, almost thinking micro etching after looking at some pics, i can’t catch anything with my nail

Finally giving my new truck the proper care it deserves and getting it protected for winter, going around with wolfgang Uber compound and a orange hex logic pad finding all these little spots, not sure if it’s over spray, clear starting to fail or something else? I can see them in areas that...

Well 4 rounds of sonnax with vigorous brushing/scrubbing wasn’t getting it

Order some wheel brightener yesterday we will see if it works keeping my fingers crossed

Ok, Just wasn’t sure if it was designed for chrome or bare aluminum vs the clear coat, I’ll give it a try

Ok, have you done any testing with any of the acids? Safe on the clear coat?

Looking for some product, and technique recommendations. I recently had a brake caliper get stuck and fling metal and rust all over my driver side rear wheel on my truck, I have been using sonnax and letting it dwell several minutes and then agitating with a tooth brush and wheel brush to try...

Ok will do the Baggie test, thanks Sent from my iPad using Tapatalk

Applied some Wolfgang sealant to my truck 2 months ago after polishing etc, still beading nice on the horizontal surfaces, not so much on the vertical, question is what is the proper procedure after washing? do I clay bar and then apply a new coat? Or am I ok to just wash and apply a new coat...

Prefer the 5.5, 6.5 seems to not be as effective with the increased surface area

What day will this be going on?

Hello from Kokomo