Recent content by brapril714

I think the issue had to do with downward pressure. I'm a large guy, 6'7" 290lbs and may have been using to much. Hard to judge 20lbs of pressure :) Either way the 5.5" pads seem to spin much easier.

Thanks Mike, always enjoy reading your write ups. I ordered some 5.5" pads and that did the job.

OK, I couldn't find any 5 or 5.5" pads in town, but found 4" and backing plate. OMG what a difference. is 4" to small other than taking a long time. Or would 5" be better.

So I've been using the uber compound with decent results. There are some RIDS I'll have to work on later. I'm wondering if the 6.5" pad is to large to allow the PC to remove enough material. Would 4", 5" or 5.5" be better?

I can not catch my nail on it. I'm using a CCS 6.5" Orangle Light Cutting Pad and speed set on 6.

Using TSR 3.0 and getting good results, all swirls are coming out, but some "scratches" are still there. I can't feel them with my fingernail, would this be a job for Uber? :buffing: