Recent content by bud659

I can see a spark when it does run. Does that tell us anything And where can I get brushes for the unit ? Or if Autogeek will service it Bud

Hello I have a Flex 3401 VRG and turns off every time I need to use. Sometimes it runs for a panel, before it turns off unexpectedly Sometimes it runs for 1/2 a panel, before it turns off unexpectedly Sometimes it doesnt turn on back at all, and sometimes it does., I dont sense any...

Thanks bob and everyone for replies The DA made a huge difference. Never will use by hand Also waited 2 hours. It doesn’t harden when dry like Carnauba but is dry enough for clean swipe test. I will wait longer than 45 in future. I think the slickness will be better with this app...

I am getting a one-day break from the 40's in the northeast for a 58 degree day tomorrow. i was looking for a few tips on applying wgdgs 3.0 cause i can never keep the slickness when do you know when to wipe off? does a swipe test apply here when it fully dries? how far will 5 drops of wax...

the bag is handled only a few times a year for detailing a few boats and one car. The flex polisher are heavy machines for these bags I contacted CS and linked them to this thread. Hopefully they can do something for me

free would be acceptable Will AG respond with good news?

Flex bag that I ordered with flex polisher ripped. It ripped along the seams can it be replaced ?

When the 2nd coat of 845 went on, the car had an amazing slippery surface. The coats I had applied were thin with a DA My wife put a coffee cup on the roof and it slid off , the surface was so slippery But After 3 rain storms, about 1inch of rain total, the slipperiness is gone. The...

It was just warm enough that I detailed black car 2 weeks ago: wash clay wash menzerna collinite 845 then last week wash 2nd coat of collinite my WGDPS 3.0 just arrived and was itching to try it out What wax work best over 2 coats of 845? I have 845 left and new wgdps Thanks!

Re: Introducing Diesel1 Roku Channel...powered by Autogeek when will marine/boat polishing be available on the Roku channel

Hard to tell by photo but I see some blotchy spots. Looks like the white gelcoat is inconsistent near the bottom. The orange pad should be fine but use an aggressive medium cut polish. Then follow up with a cleaner + wax. Marine31 line has good products

my only backing plate is the one that came with my Flex 3401. to take advantage of the 20% sale, I ordered an assortment of 5.5" CCS pads. will this 5.5" work ok? thanks for the tips :xyxthumbs:

I searched. I swear :dblthumb2:

HI all, I have been a big fan of the 3/M Ultrafina for its ease of use and the fact it finishes wet. I use a Flex 3401 polisher with a foam pad. The PO85rd has had a lot of good feedback from my searching all the threads, and wanted to ask if this PO85rd finishes wet and is easy to use...

with new orange and yellow LC Pads, my Flex DA and M105 and M205 on a warm morning day took me 4 hours to apply the M105. the M105 dried on my in many places and left lots of dust and pin-sized dried spots :mad:. i thought the pin-sized spots were chips my paint. Then I had to use my MF...