Recent content by CantHave2MuchHP

Woops, yeah I always get them mixed up.

I linked the video in my original post but basically a few sprays of Reload into a MF applicator, apply in a 2x2 area, cross hatching, let it haze a bit and buff with a premium towel.

A few ounces of APC mixed with regular soap. Makes it a bit acidic and shreds road film and wax right off. Especially after Iron X and Clay.

I'm looking for suggestions on a Sealant for my daily driver (Duramax pickup). I had some Adam's Sealants that I acquired from a buddy that worked pretty good. I recently tried CarPro Reload as lots of people recommended it but it failed pretty bad for me, was gone within a week, tested it...

Guess that's what this discussion might as well turn to...what's the best non-ceramic coating, LSP for daily drivers?

Ok long story short... I took my truck, fully strip washed it, iron decon, clay, re-wash and dried it. Paint was naked and did not need to be polished (Just did it a few weeks ago). I then applied CarPro Reload just like this video shows: YouTube The gloss was amazing and the paint was...

Great reply, thank you. You confirmed my reasoning by all the steps that I laid out. I was surprised by how much I was already told to skip. Anyways, I know that the CQuartz or any Ceramic Coating really is the way to go but I'm not ready to do that yet. If anything, I'll try that on my...

The only other Finishing polish I have that's not Essence is by a certain brand and may or may not be pronounced Atom's Finishing Polish. I'm not against using it, it pretty much does the same job as Essence for me, I will use that instead. I will evaluate to see about the claying. These...

Hello all, I have two brand new cars, a 2017 Z07 and a 2018 ZL1. They're both off the showroom and pretty much flawless, with just some factory defects. I've been researching and I've come up with a plan: Strip Wash Iron and Tar Decon Clay Re-wash Dry Light Polish with Finishing Polish...