Recent content by DustinYoung

What kind of products to coat the lens? ;) Thank you for this advice, ill pick up a gg6, whats the difference between the two, like what makes a dual action safe for a noobie opposed to the rotary?

Yeah, i wanted to pick these up, like a 1-2 in. I just need confidence and some guidance with the rotary.

Whats your setup? You use 3 in backing plate for sanding and just 4' pads? SPeeds used?

Could yousand with the 6 just with a 3" backing plate? My rotary should be able to buff and polish and I could sand with the 3"?

Pretty much what i'm looking at, should I get the 3' or 6' model?

Can I sand with this one? Can I use my Chemical Guys rotary stuff on it, the 3' backing plate from griots will fit on their 6 in m,odel?

Could one or the other do both?

I think i am going to purchase a 3' DA though, just need some suggestions.

Yeah, but it seems like a large jump. I'm going to test 1k-2k-3k. Spending lots of time on the 3k and doing more complete passes with each grit. I was doing 1k-3k because its what i did on my car with awesome results, but i do see some marks and stuff i'd like to deal with.

Yeah that might be a good idea, but i think i would run into the same problems. :/ Any advice on what DA to get?

Hey everyone, a couple weeks back i did the headlights on my Subaru WRX with a Meguiars Heavy Duty kit. The whole process worked and came out awesome (my Subaru is a 2012 so it wasn't that bad). I instantly did some research because i'd love to do something like this part time. Being an Engineer...