Recent content by Flash Gordon

Next time you apply a coating apply a little thinner and keep cross hatching until it's gone Another way to avoid high spots

Is this DJ as in DJ Mayo? I remember that dude getting his ass drug all over autopia back in the day You kids will fall for anything ... 🙄

The smart ones listen to what I say. Good job

Someone left this in the oven too long. I am a pizza expert

To help reduce sling spread the product on you pad and start slow 600/800 rpm. Work the compound in using this speed and then bump it up to 1200 M100 doesn't give much working time. You can (lightly) mist the pad with water to give you a little more time Poorboys, 3D or menzerna are a much...

1st take a picture of all of it in a trash can (and then retrieve after posting pic)

No secrets. I just don't think about it Had a young Hispanic guy tell me today that I work harder than a Mexican Maybe I'll take up roofing or brick laying and make some real money 💰

Waited too long and applied too heavy would be my guess.

I'm coating cars (outdoors) in 108° heat with 0 issues Its all in your timing and process

I would deflate to 24lbs, move that tire to the rear and squeeze another 10,000 miles out of it

I've driven on worse than that for sure 😀

If it's smeared from improper cleaning (armor all rag) put a dab of Vaseline on a (clean) microfiber rag and spread it around. Once done with that wipe clean If it's just hazy from being old (and it's plastic) try Plastix by meguiars using the same process as mentioned above.

Is coming across cocky and being a dick one in the same??

Or put a sticker on top of it. Maybe a flame job 🔥

I start in the back and work forward I also tend to find the passenger areas dirter (especially spills) than the drivers. You can't have nothing nice...