Recent content by Ginnova

This is the same reason i bought a couple of BDX. If it was specifically mentioned its RTU then i would have sticked with IX.

Oh , I thought you're selling gg3 to get another machine. Yes the 3in should be fine on the gg6.

My MT-300 had the same cord problems as the OP. And it was used only for a few cars. https://www.youtube.com/watch?v=PG1hxFcsA7o&feature=youtu.be

Instead of getting a GG6 , get a PCXP instead. The counter weight housing is much smaller so you can view the pad much better. The pcxp also has more than enough power to rotate the pads even with heavy pressure. I have both 3in and 3.5in backing plate but the 3in backing plate is more...

Are there any specific waxes or sealant for ppf ( xpel , etc )?

the bp should fit directly. no adapters needed.

Happy Birthday Mike

Sub'd!

Seems the same as the fuzion.

and for less than ~$30 a gallon, D151 is hard to beat.

Pinnacle Souveran for looks and ease of use.

I have DP coating on my car and would like to try the how well these products restore/enhance the beading of coatings.

^ +1 . 1 of my bulbs is busted as well.

The copy and the original looks almost the same. The counter weight is exactly same shape as well. Noise level for both machine is almost identical with the copy slightly louder ( might be due to the more powerful motor ). I did not experience the hopping up and down maybe because i did the...

how's the cut compared to the LC thin wool