Recent content by Girn

there is a way.. polish it till there is no clearcoat left

i cant go slowly as i would with a 6.5 inch pad or else the polish will disappear.. but i guess if i want to go as slow as the 6.5 inch pad id have to use speed 4.. but so far with speed 5 and going double the speed as the 6.5 inch pad seems to be working.. but its still relatively slow as with...

ya i think i figured it out.. i was going at the same speed i would go with 6.5 inch pads which was snail slow.. and i used speed 5 instead of 6 and it seems to be working.. im going at about double the speed as I would with a larger pad because the small pads seem to generate a tremendous...

man i have no idea why this is happening im stumped.. i tried again with a new pad.. i misted it 3 times.. put quite a bit of polish on.. worked on a very small area that i tapped off.. spread the OP with orange 4" pad on speed 1.. started working it in on speed 6 with one pass.. took a look at...

a small section.. i dont know whats going on man after 1 pass the polish is almost all gone

im doing my fender right now using OP on an orange 4" pad.. then i started using OC on the same pad.. and for some reason when i lay the polish out on speed one and spread it out.. then start going over it on speed 6 the polish disappears as i go over it!! i tried putting more polish on my pad...

took me almost 2 hours on the godamn hood!.. first i had bad dusting i dont know why.. the pad was clean, i sprayed it with water so it wasnt dry.. i didnt have too much polish on it.. so i dont know why it was happening.. i tried shaking my OP bottle for at least 3 minutes vigoriously and it...

can anyone else give insight? thanks

i think it may require lower then 1500 to start off with.. but im not sure what grit to start from.. there is no cracks..

Hi there, I recently got into an accident and my headlights got messed up.. im just wondering what grit to start at and what grits I need to fix my headlights.. I dont want to buy any headlight restoration product or kits.. id like to use what I have.. i have a meguires polisher with plastx and...

im from canada BC and when i buy from here i dont have to pay any dutys or fees when the package arrives at my door

ya the opening at the back of the mf bonnet is so freaking small that the 3.5 inch backing plate will fit the velcro on the back of the pad but its snug.. ill try the 4" pad and see but i think the 4 inch pad would be too small to fit well in it.. maybe its meant for a 5.5 or 5 inch or soething...

i still dont see how it would fit over a wool pad either.. i mean the opening at the back is so small i can barely get a 3.5 inch backing to fit on the velcro.. let alone get the darn pad get inside

On my last order I purchased 4 mf bonnets 6.5 inch as it says so on the order recieipt, and today I decided to test them out.. but these BARELY fit over the 6.5 foam pad.. its soo soo tight and the pad is smushed inside of it.. did I recieve the wrong size bonnets? are they suppose to go on...

i thought my car was hologram free and now i see its not wtf.. can i get rid of this with going over it with poliseal on speed 6? u can barely see them with my camera but in real llife its a lot more apparent. *edit* going over it with poli-seal got rid of it.. but it seems like when there is...