Recent content by In Debt

Thanks for all of the feedback.

What is the best cleaner/protectant to use for a a soft tonneau cover. I have seen many different products out, didn't know which was the best. Thanks for the help.

No, I can't catch them with my fingernail. What's DD?

I have been working on truck all day and I am pleased with the results for the for the most part. My question is there are little spots on the surface that look like little holes in the clear coat. I am using a PC with a LC orange pad and Meg UC. I went over it several times and they wouldnt...

What is a IPA wipe down? I here alot of talk about it.

I bought some UC this morning. My questing is, if I get some swirls left behind from the UC, what would be a good follow up polish out of my lineup. Should I get some UP or try my Z5 followed by Z2? Getting excited to try everything out. Gonna wash, clay, and tape off tonight and get up early in...

I am going to try a test spot to see if the ZPC will do the job, If not I am going to get some Meguiar's. I appreciate the link. Thanks for the clarification Mike.

Knowledge is power, I appreciate all of the help. Is the M105 the same thing as UC?

I was thinking about that as I was reading how to properly prime pads, I would use more priming the pads than I would to do the whole truck three times by hand. Would you even try to use ZPC on a pad to get the swirls marks out or would you use the Meguiar's UC on a pad to get them out?

I will try that, I appreciate all of the input. I will let you know how it goes.:buffing:

I didn't know if I would achieve better results with a blue or red LC pad.

I meant to say I am going to try the ZFX and see how it works and use the Meguiar's as a back up plan. Thanks again for the help.

Thanks guys, that was the input I was looking for, and I am going to use the ZFX. I will get some of the Meguiar's UC just in case I need it. What would be a better polishing pad for the PC? Thanks again for all your help. I will take some pics.

Any good pointers for a Newbie like me? My plans it to wash, claybar, rewash, correction with ZPC and a orange LC Pad, put a coat of Z-AIO with a white LC Pad, couple of coats of Z-5, and couple more coats of Z-2 with a gray LC Pad. Should be a long day. I have clean MF's, some really good...

If the ZPC doesn't have enough bite to get the swirls out what would a good replacement?