Recent content by Johnnyboy

Hello Mike, any chance I can have a PDF version sen to [email protected]? Thank you!

I mainly focus on detailing but also offer powder coating and plasti dipping. In cases like yours, hard to reach and plastic trim areas, I keep Goo gone spray GEL handy. Spray....soak....and pressure off. for any other areas, I keep a some Xylene around (which is actually an ingredient to...

I see most of you have your personal names on your cards. Do you guys feel there is an advantage to this?

I use the Grey Tolco "T" sprayers for everything. I get them locally for $1.25 and $0.50 per 32 ounce spray bottle. I have had the same sprayers without replacement for the past 5 months and except for one that I had to replace because I dropped it and landed on the trigger from a high distance.

I've seen this happen with 303 before but it was due to the fact that the dash was already beyond help and ashy beforehand. The sun had already eaten through the top layer of the dash and it didn't help that the owner usually wiped down the interior with too strong of diluted degreaser to wipe...

HD Adapt.......White pad......and play with the hand pressure on the machine and done. That Orange pad is causing the marring. I've used the same combo numerous times with great results.

I use the dryer set to low for 5-10 mins (depending on how much is in the dryer and then switch it to "Delicates" for about 25-30 more minutes. For me, microfibers get HOTTER drying in the Florida sun than in the dryer. Plus, nothing I hate more than washing all the towels and hanging them to...

Some people attribute this to heat. I've only seen this in factory finishes (at least in my experience) and I had a painter tell me once that he feels it could be from the paint "baking" process (which falls back to the "heat" thing) and having the heat source to close and too long on the...

Mix of rock chips and bad case of crow's feet!

Congrats man!

Re: Mike Phillips - Vehicle Inspection Form - Version 2 Hi Mike! I'd like a copy if at all possible! Thanks.

HD Speed for me. I tried a sample and have never used another AIO since then. I have had great results with MF pads or foam depending on the hardiness of the paint.

I'm needing to have a reliable detailer in Detroit that can assist a would be client. Unfortunately, I am in South Florida......and that's quite a drive so I can't help her. Either PM me or let me know who you recommend so I can PM them. Thanks in advance!

I use HD Speed AIO and always use CG V07 spray sealant on top.......but it's just a spray sealant.

Great turnaround while it lasted! Judging from the very dirty tires just 3 days later, I'm guessing maybe they decided to do a little "off-roading" and tried to clean it up after......big no no obviously!