My wife has a new vehicle arriving this coming week. Part of the seats are leather and the bolsters are a material that is either alcantara or a material called ultra suede. I have been using gtechniq L1 on my seats and I have liked it for ease of cleaning jean dye transfer off. Her seats are an...
I previously have used gtechniq L1 on my interior leather seats/dash and I was wanting to try cquartz leather 2.0 next. Will a different coating bond again or is there something have to use first to make sure whatever residual L1 is removed?
About 2 weeks ago I started on my mother's fairly neglected exterior. I had washed, chemical/mechanical decontaminated, and was about 2/3 of the way through cutting with carpro ultra cut with plans of following up with sonax nano 3/6 polish and cquartz uk followed by gliss. When I was about 2/3...
I purchased a new vehicle a couple months ago and did mechanical decon and put dgps and topped the next wash with sonax bsd as I planned to fully decon, polish, and cquartz the car this week. Unfortunately my available time has changed and I will not be able to get that accomplished anymore. My...
I have not compounded a car for a couple years now but looking for advice for what new product advances have come out. I previously have used menzerna heavy cut 400 and liked it at the time.
I bought a new vehicle but it sat on a dealers lot for about 9 months and the paint has quite a few...
I just picked up a white bmw m3 and want to have it wrapped in xpel stealth ppf. I have a few questions as I have never had ppf before.
Since stealth is a satin ppf do I need to do a light paint correction prior to taking it to have it wrapped?
If still recommend to do a light correction...
About 15 months ago on a new car I corrected and applied Cquartz UK followed by gliss. I think how water acts on the paint there is still some level of cquartz left but figure should be redone soon before it gets too hot for comfort in the garage. Would a "quicker" once over with a medium cut...
I just coated my car with CQuartz UK and topped with Gliss. I trashed the towels that touched the CQuartz but can I wash and reuse the towels that touched Gliss or is that bad idea?
I looked on the instructions and website but can not find an answer. Is there a recommended temp range for application of flyby forte? I was going to put it on today but is high of 38F here and didn't know if would cure at that temp?
I recently bought a new car and am going to put a sealant on it in the meantime till I have time in a couple months to fully prep it for a coating during some vacation time. I was going to Iron-x, "clay" mitt and then put sealant on. I have read PNS can be applied on top of other products or...
I have been out of keeping up with detailing products for the last few years do to working on the road but now I am back to a single location and plan on getting my car back to how it deserves to look. Previously, I used menzerna fast gloss as a single step cause it finished so nice but seems...
I ordered the crystal serum light and exo v3 combo and wanted to apply it soon. My question is does either product need to be applied in a certain temp? I remember I used a product in the past that for it to cure correctly it needed to be applied to a panel that was at least 70 F. I didn't see...
gtechniq combo for sure. I did that to my dd and its amazing. I have tried many of the coatings on family members cars from 22ple opticoat and gtechniq and the c1/exo is my favorite by far