Recent content by pattcook

Just dropped unit off t service center in W. sacramento. the mechanic was pretty sure it was the bearing on the spindle shaft.

Yes its seated properly. Its aligned . I have taken it off before thats why I,m stumped. The gears mesh and the bp slips on properly. Then the unit won,t rotate, either with power or not. I thought may be a part fell out or slipped or whatever but with the bp off the unit seems to operate...

just went out and checked the lock button. With the bp off it works normally. When I put the bp on the machine tries to rotate but is jammed and wont move.

What I don,t understand is the gears on the bp mesh with the gears on the unit but the gears on the unit won,t budge. Aren,t they supposed to turn also?

I recently switched to the edge conversion bp. The unit always ran hot but it seemed to really run hot with minimal use with the edge. When I switched back to the original backing plate now the unit is jammed and won,t run on either bp. With the bp off the unit runs and rotates but when I...