Has anyone tried using different types of water (distilled, filtered, tap, etc) while diluting OID? Have you noticed any difference between them?
I'm wondering if it would make a difference...
I didn't think I was adding pressure but then again, it happened to me on the vertical panels so I'm probably applying too much pressure while holding the tool to paint.
Mahalo for all of your feed back!
I used a 5.5" Orange Flat Pad and 4" Orange Spot Buff for compounding, but only the 5.5" Flat Pad overheated on me... granted the Spot Buffs are thick like the 6.5" pads, so that could be a reason why...???
Planning on using the same sizes for RED... WHITE... and BLUE;) (proud to be an...
After reading, yes. :xyxthumbs:
I had no problem with the 6.5" CCS Pads (due to it being thicker than the 5.5") but after a while when the pad was saturated with product, it didn't have enough power to spin. After reading some posts, others recommended the 5.5"...
I was about 80% finish with my first coat on an Accord when the compound was forming a paste when applied to the car. I noticed that my pad (5.5" Flat Pad) and BP (5" LC) was extremely hot. I'm not too sure if it's because I use too much product... but after every panel, I would clean my pad on...