Recent content by Ragas

Poorboys Natty blue. It a boutique wax in a simple container. Longevity of 7 Weeks in hot, dry ,dusty Indian conditions. In more forgivable environs it will last you more.

Helpful review Mike. How would you compare the performance with say, Ultima Waterless wash , in terms of dirt lifting ability and surface slickness?

Water would just not penetrate the thick layer of wax even if used from a pressure washer. The wax would break the surface tension immediately and water would bead up.. Beading will be awesome though...LOL Try spraying QD, like ONR or UWWP in clay lube concentration and tackle small section...

Another hyperwash fan here. Amazing lubricity and cleaning ability. And at that dilution, hits the nail on its head. Clean fragrance too. 15ml in 10lts of water is all that is needed to clean the whole car with two bucket method

In case the PBL coating is not immune against compositions such as spotless,it would be better if the same is mentioned in the product description so that customers are aware of what they use on coatings. Since there are so many coatings available in the market currently people take some of...

I understand your point . My thinking was in a different direction . Spotless used on CQuartz does not remove the coating . Hence the conclusion that pinnacle coating is not immune to spotless. Sent from my iPad using Tapatalk

So basically carpro spot less removed the pinnacle glass coating? Does it mean pinnancle glass coating is not immune to carpro spotless?

Applied a layer last week and must say it goes on and off real smooth .A moist foam applicator will ensure that the applicator does not grab the paint during application.I observed that the applicator required couple of misting with QD before completing the whole car.Used UWWP as QD. Purposely...

Have a Karcher K3.550 which is approximately 1750 PSI which comes only with a fanning lance which would not harm the paint even if distance is less than a feet Earlier had a Bosch Aquatak which was 1450 PSI but had a 0 degree lance which would throw the water jet like a needle. This ripped the...

Oh that's a bummer! So am i forced to purchase a Poor boys sealant to go with the BH? Somehow i am not liking this Poor boys system inter dependency. Never had this issue of cross usage of products with other product lines that i use

Do not have any other glaze other than Black hole. Yes, my experience with BFWDAFPP earlier has been good. Like mentioned in multiple posts looks like Black hole is the culprit. Will wait for another month before the smoothness wears off and then will strip down everything and re-apply. Since...

Do not have any other glaze other than Black hole. Yes, my experience with BFWDAFPP earlier has been good. Like mentioned in multiple posts looks like Black hole is the culprit. Will wait for another month before the smoothness wears off and then will strip down everything and re-apply. Since...

Yea it's nearly 40 degree Celsius here in South India [emoji3]. Water is sheeting well. Especially on the vertical panels where hardly any water stays a minute after rinsing The whole point of applying a glaze is lost if I use IPA before sealant. Anyway lesson learnt. Have read few threads...

Don't have duragloss products with me currently. The mild car wash was with megs hyperwash at 20ml in 3 gallon of water. So that should have removed the dry dust. Besides the surface is as smooth as a baby's bottom after the wash and dry. The problem is with beading. Like mentioned above...

Well, I applied black hole with a white ccs pad on a rotary at 600rpm. It was wiped off well. I am sure of this because the product was caking a bit on the paint so had to use extra elbow grease in some places. The first coat was applied immediately after black hole. The conditions outside...