raysaint's latest activity

I think I'll try a mild compound, by hand. Before that, might as well try hot water and baking soda paste, can't hurt. Even read that a...

So the spot on the hood, it's small and almost looks a bit wrinkled. I may leave it alone, only I see it. The bigger spot on the side...

I'll see if it shows in a photo. However, I just noticed another big splotch of bird poo, just tried APC and Tarminator, and I can still...

Started spring detailing on wife's car, 2023 Soul Red mazda. Just doing a wash, Eraser, Klasse HGS process. Near the top of the hood...

Appreciate your candidness and experience. I'll go with primus and then a good contact wash. I'll clay and/or polish only if necessary...

The website says it only removes dirt, doesn't harm lsp's. Will it be enough to strip away the old lsp, or does that matter before...

If it does need a mild claying (towel), would a non-abrasive polish, Klasse AIO, be sufficient? I did abrasive polish last july, not...

If I use the IK Multi Pro, no foaming pressure sprayer, the dilution ratios are confusing for Primus. Each paragraph is different. "For...

If I just go high alkaline soap, can I use a Ik hand sprayer and just spray it on without foam? Watched a vid where they did this; they...

I'll look at the paint in the sun, if there are swirls, I'll polish (non-abrasive.) But if I polish I probably should lightly clay it...

Even if the polish is non-abrasive?

Car: 2023 red Mazda cx-30, new in November 2023. Did iron-X, clay, Klasse HGS (I have some to use up.) Last July finally did a full...