Just cleaned my headliner. First time doing it. I was going to spot clean it until I realized how dirty it was. I ended up doing the whole thing. Mine is light grey. I used Chemical Guys Lightning Fast Carpet Clean & Stain Remover at about 14:2. I sprayed it directly on a soft brush and...
Yes, the new version fits both the 1.25 & 2.5 hoses. It came with the vac I purchased. I really didn't like it that much because it wasn't smooth gliding. Maybe to much suction. I will have to try your suggestion and drill the whole in the sides. Thanks Rob
Hey Mike,
I was thinking about a G9 and I asked Griot's about the supported 5 inch backing plates, specifically if the older version(V1) vented plate would work on the G9. Their response was, yes. Have you tired one on the G9? Do you know what or if there are any differences between the two...
Thanks Guz,
You also answered my next question. It would have been about the other specific coatings. The surface becomes more cost effective.
For a daily driver that is outside 24x7 will the surface coating last a year if maintained well?
I am leaning to either the PBL sealant or the...
Looking for information about the PBL coatings and process. What is the difference between the surface and paint coatings? I have Meguiars Ultimate Polish and M205. As I understand it for a coating a pure polish is needed. Is the surface prep spray ok to remove the oils or do I need to...
Coatingsarecrack, Thanks for the recommendation.
Mike, Thanks for the very detailed response. Your words carry a lot of weight. I am going to read a few more of your articles and see what products and equipment I will need. And then make my decision from there.
Thanks again
Rob
Hey Mike,
My question is about glass polishing. In your bucket list ’68 Shelby Buff you showed a close-up picture of the windshield with light wiper marks. There you used Griots Light Glass polish. You didn’t show a close-up after polish shot. I also noticed in your RAGTOP how to you...
Has anyone compared the cut of the Lake Country orange flatpad to the Meguiars burgundy disc? Ihave used the Meguiars disc and I have the LC orange. I only have two of each which is not enoughto complete a car. At first I thought Iwould only use them for spots. But itturns out the whole car...
I picked up a new GG6 over the winter. Being in the northeast I am getting ready to go outside and try it out.
My question is about the replaceable brushes. How do you know when the brushes are going and need to be replaced? Is it hours of service or workload? Does it stop working, vibrate...
I am getting a GG6 for Christmas. I currently have PC with a 3.5" & 5" lake country baking plate. I am thinking of using just the 3.5" on the PC and the 5" on the new GG6. So, my question is. Would a weekend warrior notice difference between the LC 5" backing plate and the GG vented backing...
Does anyone use a LC backing plate with Meguiars foam discs? Have you had any issues? How is the hook and loop holding up?
I am debating on either the Meguiars discs (yellow) or LC flat pads (green) for my next pad purchase. Since I only have a LC baking plate if there are any issue with it...