Recent content by thebouncer

I have the CarPro Pads and the Cerium Oxide using a Flex Polisher. I also have a water atomizer spray bottle. I have been working on the glass for an hour and much to my dismay it seems to be adding chicken scratches into the glass on the 2000 Corvette I am working on. This doesn't seem normal...

I applied Dr. Colorchip and as shown in the photo it does not match the car color at all. Does this darken or change color once cured ? If not then this color is wrong and I supplied the proper paint code which is PBV. Also I tried the smear technique and each time I do it, it turns the...

So I started using Langka blob remover to try to remove the old touch up paint, I have been at it for an hour on one large spot and still the touch up paint is coming off. Is there any way to speed up this process by machine or something? or would acetone work better or would that eat the...

Ok so I tried M101 and a LC Hybrid Light Cutting Pad it is fading these marks but they are not completely gone... would going to the heavy cut (Grey Hybrid LC pad) risk ripping through the clear or would I be okay ?

should I go to wool or is that going to be too aggressive ? or should I change to M101 instead of Uber Compound?

Yes most of them are. there are a few which are not.

I have "Iron X" other than that no.

I am trying to correct the paint on 2011 Blackberry Pearl Jeep Liberty. I washed the vehicle and the began paint correction using a Flex Buffer and Orange/tangerine Lake Country Light Cutting Pad with Wolfgang Uber Compound. I then switched to a Grey Heavy cut LC foam pad and then went to a...

Mike thank you for all the information. I will look at those videos and reply once I have. It is Factory Touch Up Paint, Paint Code PBV which is the same as mine as we both have the same color vehicles. I think I may have discovered the reason for the discoloration; no clear coat was ever...

My girlfriend applied factory touch up paint to a bunch of her chips and deep scratches on her 2011 Jeep Liberty (Blackberry Pearl color). The touch up paint is uneven with blobs and also the color has changed drastically from the rest of the paint. When she first did it, it matched for the...

I was reading through this and wondering if something like this light https://www.amazon.com/LEDMO-Waterproof-4000-5500lm-Equivalent-Security/dp/B01NBAOS85/ would work better than the 2 LED floodlights and could be mounted to a stand with casters and boom arm ?

Hoping someone can answer this as I am a bit unclear. I am looking at getting the CR spotless system. Also looking at a foam gun and pressure washer ? can all of these be hooked up together my water last I knew was around 8 for hardness on a scale of 1 - 10 or around 220 TDS. There is also...

Quick question on buffers, Which one (Rupees or Flex 3401 ) would do a better job out of removing swirls and scratches and which one would make a faster job out of removing swirls, scratches etc. ? When you say white pads I'm assuming you mean wool correct?

Are these the correct ones ? Foamed Wool 5.5 x 1 Thick Polishing / Buffing Pad

Is the purple wool clear coat safe or can you burn through it and what would I follow it up with next pad wise and chemical wise from the FG 400 ? What is the difference in the black microfiber with the foam backer vs no foam backer on the griots ?