Search results

Personal preference. With the smaller pads it will take a bit longer but you will have no problem getting to the edges of the glass

9h and Crystal Serum would be my top two.

Short answer is yes Here is a write up all about the compression washer The Compression Washer

What about Jim Goguan

Try a pumice stone on the carpet. This is a great tool for hair removal so it may just work for you with the mulch.

If you are having issues with bubbles you can spray a mix of IPA and water. This will help promote the adhesion of the film to the surface. I would on use that in those areas. Are your using and installation gel to spray on the surface and then laying the film down?

I have had the opportunity to spend some time with the XCE and it is a great machine that runs much cooler and more quiet than the 3401. As per Bob E of Flex NA the XCE will not replace the 3401. It will just be another tool in the line up I love my 3401 and I know it's a solid machine. The...

Who's this Marc fellow never heard of him!!!!!:bat:

I have the entire front end of my car done. Full hood, full front bumper, full front fender, full mirrors, A pillars and leading edge of the roof After install total cost was about 1200 all Xpel ultimate. I will never own another that does not have the full front done on it.

For those that feel PNS is difficult or has the potential to be difficult to apply here is my method I have used time and time again to apply with ease. How To: Sonax Polymer Netshield Paint & Wheels

With the BSD it will last you about a month or so as far as protection is concerned. My suggestion would be at the 3rd wash instead of doing an application of BSN you would be alright to go ahead and add a layer of PNS

I like to have a SM Arnold fine and medium mitt. Most vehicles I do are getting a correction so I will use the medium grade mitt. For my express and new vehicles I use the fine grade mitt.

I am a fan of the suede applicators. I feel they give a uniform application without having any pressure points. Plus you can throw just the towel away and grab a new one. C1 takes me about and hour to coat and EXO about 30-45 mins per coat

I want to add if you do use a razor blade make sure it is a Stainless Steel razor. Carbon blades or anything other than stainless steal can etch the glass. Even a stainless steel blade can etch so be sure to use something as a lubricant on the glass along with the blade.

I have done the C1 and EXO many times as well and I use 3 towels for C1 and 2 for EXO. As said already temp and humidity play a huge role in how these coating react during and install. If it's flashing too quickly then make your work area smaller. Use as much light as possible to get all the...

Does the area look dull compared to the the area that you didn't use the eraser?

This application method is still my go to for SPNS.

Here is a write up I did on how I get streak free glass

I was my mitts after every car. Think about all the dirt that can get trapped within the fibers, then ask yourself if you had a new car would you want that mitt you used on another car that was dirty? More than likely due answer would be no. I like to work less and not more. With a dirty...

Those solution you had mentioned work great for above surface water marks. If the water marks are etched into the paint the you will have to abraid the surface with a polish or compound to level the paint to remove the water mark or etching. As it has always been said start with the least...