Search results

I have the Vapor Chief and it runs 275 degrees at the tip. Fortunately the pressure can be adjusted. When cleaning interiors I tend to start at 30 psi with a thick MF towel wrapped around the triangular brush. Once the towel gets saturated, I will turn off the steam and keep cleaning...

What are "wheel woolies?

Most of the above and when you wax your guitars at least once a month.

Cee Dog, Thanks for responding and what a GREAT comparison.

What is "IMG code"?

I have the DP paint clean clay and CG's professional heavy duty clay and will test both tomorrow. I also will use Optimum's polish starting with a white pad on a test spot. The motor is also loaded with crud and I will try to clean it. I have a good friend who owns his own mechanic shop and...

A friend of mine recently asked me to help clean a car. I usually don't mind lending a helping hand, or offer advise. In this case it is a 1988 Oldsmobile Delta 88 that has been basically sitting outside for the last nine years. Normally I would not take on this type of project but I wanted to...

Where did you get the drill attachment? Would you happen to have a picture of it?

Chris, Any particular brand of sandpaper? And where is the best place to purchase? Maybe a paint supply store?

Thanks for all the feedback. As for products I have: Optimum compound, polish, and finish polish. Pinnacle XMT 3,2,1. Mazerna super intensive and super finish polishes. I could use some advice on what grit sand paper to use and the best type of block.

I have been reading and researching about restoring headlights and was wondering if anyone has used Optimum Opti Coat? If you have a product that you utilize for the final step, or have suggestions, I would greatly appreaciate the information.

I don't think so. I have done several motorcycles and they can take several hours for a complete detail. Most bikes that I have detailed range anywhere from $100.00 to $150.00

Where do you purchase the G1 products?

Let me know how the hex ogic pad work out. I have been thinking about trying them myself. As for the smaller backing plate, I am curious about the amount of pad hanging off each side of the plate. Will this cause the pad to not work as effectively?

I just placed an order and claimed two bottles...will let you know if they are in the shipment.

I have purchased another backing plate for the Flex and intend to cut it down to use with 5.5" pads. Hopefully it will perform better with this set-up. Has anyone tried this yet? If so, how much better did it perform with the smaller pads?

Any advice on the Hydro-tech pads?

Thanks for the explanations and advice.

What is the advantage of switching from a 6.5inch CCS pad to a 5.5 inch CCS pad? I have both the GG ROB and the Flex 3401. Besides the pads being cheaper, is there an advantage when correcting paint? I am planning on ordering some more pads tonight and would greatly appreciate some feedback...

Thanks for the feedback