Search results

Any word on getting a write up of the build?

I was thinking about getting the door sill guards like shown above for it. Or protecting with 3M film. The area I am talking about is the synthetic soft plastic like material in the areas surrounded by red in this picture.

Does anyone know anything that would protect kick panels or the area that you commonly step over to step out of the car. In the accord we just got its a black synthetic/plastic like plastic that is getting a few scuffs. I mentioned weathertech mats and that seems like it would work for the...

Same, have had to get a few of those out of mine as well. Great job! :props:

I actually went out and bought the Quik Wax last night. After some research after purchasing its been confirmed that D156 is the same as Quik Wax other than the smell. As for the detailer, I'm not sure what the detailer equivalent would be, but I suspect its last touch or something. $32 for...

Is this what you used. If so, it clearly states that it does not strip wax.

I've bought and used the HF DA and pads, worked fine.

Been thinking about pulling the trigger on forever black for my bed rails and bumper. Only works on black though.

I have one of the Ansi Auto Rupes knockoffs. And I have indeed attached a Rupes 5" backing plate to it and use Rupes pads. Everything works fine after a little bit of tweaking. Its not exactly easy to do as I did have to open up the rupes backing plate mounting hole on the back a few hundreths...

I alternate between Car Pro Wool mitt and Autozone green MF chenille, and a smaller green autozone chenill for the bottom of the truck.

Well... calling a gtechniq authorized detailer and saying you dont want that but for him to instead apply opti coat or cquartz may have done it. Like me asking chemical guys to detail my car with only meguiars products.

I ran into a few issues with mine. One being that the rubber vent shroud between the backing plate and the head of the polisher was getting caught and eventually melted the back of my backing plate a bit. I tried cutting it back to the back of the vents but the thing is really loose and...

Look what I saw on one of chemical guys youtube videos promoting their smart detail university....

When you're on speed 1, it seems to go higher than 1 and then come down and settle on a low speed. When you're on speeds 3-6 it does appear to ramp up from a lower speed and then up. If you're holding the trigger down and let go for a second or two and hold it down again, it slowly ramps back...

[ame=http://www.youtube.com/watch?v=6MLd370O0Uc]Ansi Auto Rupes 21 Clone - YouTube[/video] Just a quick video with some pictures and a small video of it running at speed 1, 3 and 6. My stuff comes on the 6th with the 5" backing plate and the 7" & 6" foam pads, I also have 5.5" nano scrub and...

Just received mine its an AnsiAuto 21mm clone Rev.2. Built pretty well and surprisingly solid for a copy. The one that i got is the redisigned batch where they improved on the vibrating issue some complained about and I got to say its really smooth. I have a Rupes 15 5" backing plate and rupes...

I have the DA autoscrub pad. Love it for my large truck, use it with ONR diluted to clay bar lubricant specs. Really fast and any spot I can't get to I just break out clay at the end.

If its the foodsafe ones with the green kid label on it then yes, grit guards will fit. :xyxthumbs: