Search results

Anyone ever used a machine to clay a vehicle. AG sells a pad to use with a machine. Paintwork Clay Pad Applicator I did a search but could not find any info about using a machine. I have always clayed by hand.

Hello Mike and everyone, I apologize if this has been covered before, but I cannot find it. What is the proper way to use a spur for cleaning pads? Maybe I am just dense and it should be common sense on how to do, but I am just not sure on the correct way. Thanks

Will Collonite 845 stain black trim like other nubas?

Anyone else have one of these? I have purchased one but only one of the batteries will work. It shows that it is charged but when I put it on the drill nothing. The other battery works fine. Has anyone else had a problem?

Does anyone know about a washer that is for the 7424? A friend who also has a PC7424 told me I shoud have a washer that goes on between the machine and the backing pad. If I don't have one it can cause overheating. I looked and don't think I ever had one on it.

Has anyone every used onr on the interior plastic, vinyl, and rubber? Would it be safe to use this way? I really like the way it cleans the exterior.

Does anyone know if a smaller backing plate can be attached to the 3M adapter? Does the 3M adapter have a 5/8 inch diameter shaft? I was looking at the 4 3/4" or the 3 3/4 " backing plates. LC-43-095 3 ¾ inch Rotary Backing Plate LC-43-125WH Rotary 4 ¾ inch Flexible Backing Plate Thanks.

My wife has taken over my new autogeek car wash bucket, and my DP 4in1. She was using it to mop the tile floors and now I don't think I can get it back. She ran out of the regular floor cleaner and decided to use my 4in1 to try. It did a really good job on the tile. Oh well I guess I will...

I just wanted to say that Autogeek is the best. They have the best products, the best prices and the very best customer service I have found. I went to my first detail fest and the people were so very nice. I got to see a lot of products first hand. Also this forum has a great group of people...

Just wanted to say that XMT products are my favorite line of products. Since I started using them, they have exceeded my expectations. IMO this is a great group of products and a good value :buffing:

What type of Detail Spray would be good to use on Klasse SG? I have see on some other sites that they have Detail sprays with acrylic just for Klasse. What are your thoughts on which detail spray is best, or does it matter? Thanks Feed back please

I am not sure that I understand how QD spray and Clay Lube are that much different. Some QD says it can be used as a clay lube. Also DP 4 in 1 can be used as both depending on the mix. Can you use a clay lube for a QD? :confused:

I like the fact that you can use the XMT Products in the direct sun. Are there any other products that can be used in the heat and sun?Feed back please

I am new to detailing and need advice on collinite 845. Do I need to do anything specail to prep before I apply the 845? Can I just do a normal wash and apply it? Thanks for your advice I have never used this product before.

Hello everyone I am a newbie from SW Florida.