Search results

Thank you all. I will get some of the OPC.

Inside the door jams is an tweed ring place. What I have tried so far for QD and waterless wash don’t work well on that location. What is a good product that removes grease in the door jam as well? For years I have used Incredible Pink from Chem Quest in Gorham, Maine. But they are out of...

It buffed out!

As shown in the first photo, my 2013 Sierra Denali package had this trim on the doors. I knew it was full of mud because I can never get it to stop running out of them when washing. I finally decided to remove them. I started with one side in case the result was poor and I want to put back...

Thanks. I just read a similar approach on the KLASSE product page. I have 3 cars so if you were closer you could take out your frustration of lack of a car detailing them. Granted, they are work truck and minivan so not that exciting.

Thanks. I don't have any other products yet. I only bought a Flex 3401, a lot of pads, cleaner and conditioner, lots of towels, the Poor Boys Master Cut, and the Klasse AIO. Plus some cleaning stuff. I don't mind the learning curve. Plus, if I try it out on the RV that is a lot of real...

Ok. I just looked up the Sealant Glaze. Maybe I should put that on the RV as well? I found the compounding polishing was a ton of work as it is all vertical and I forced myself to do full section passes without cheapening out. But, the Klasse AIO was a ton easier so I imagine doing the whole...

I spent about $600 so far to get initial stuff to do the RV, and of course most of that carries over to the cars (I bought a lot of pads), and as you can see in the pictures, I got $5,000 worth of happiness. You can see the front cap in the first picture and I had not done that yet. What a...

Thanks. But I am a bit too new to this to know what "KSG" stands for. I don't know why the paint doesn't show swirls after 3 years, but it does look good after I wash it and dry it without anything else. And if it looks good to me then the average drive through car wash person probably thinks...

I bought a Flex 3401 to do my first project. It was a 37' camper. Thank you all for your posts as I got good at it and using Poor Boys Master Cut and Klasse AIO. Master Cut suggested a rotary but the DA did a great job and I was doing it an hour or two at a time after work over the past...

Fastback!