KMG
New member
- Aug 26, 2013
- 661
- 0
So the owner just purchased this car a week before he brought it to me. I had not done a pre inspection of the vehicle like I normally do due to our schedules not allowing it, so I was not sure what I would be getting. Needless to say when I saw the condition of the car I was pretty surprised, as most of these are in pretty good shape. The car was covered in swirls, lots of RIDS and plenty of holograms from a previous detailer or dealer I would assume. In previous discussions with the client he just wanted it cleaned up pretty good for the time being, and said he would bring it back this winter for more extensive work.
Here is a video I shot after being washed showing the condition of the finish.
Another video I shot after completing the car.
Now for a few picture of the vehicle.
Wash Process
This is a picture before I started the wash/decon process.
The car was foamed to begin the process like usual.
The foam pre-soak with followed up with a 2BM method wash.
After the 2BM wash and being treated with Iron-X and thoroughly rinsed, the car was washed one final time with a Nanoskin Mitt.
Paint Condition After Wash
As you can see the paint was in rather poor condition, lots of swirls, rids and holograms.
The entire car looked this way.
Correction Process
This was my first test spot, which was Hyper Polish on an Orange LC Flat pad. The results looked pretty good however there were still a lot of RIDS left in the surface. I ended up finishing the vehicle with FG400 on Megs MF pads.
Before
After
The workhorses
Finished Pictures
After finishing the compounding the car was pulled out and quickly washed again, the sealed off with Hydr02.
Sun Shots
Interior Shots
Thanks for taking a look.
Here is a video I shot after being washed showing the condition of the finish.
Another video I shot after completing the car.
Now for a few picture of the vehicle.
Wash Process
This is a picture before I started the wash/decon process.
The car was foamed to begin the process like usual.
The foam pre-soak with followed up with a 2BM method wash.
After the 2BM wash and being treated with Iron-X and thoroughly rinsed, the car was washed one final time with a Nanoskin Mitt.
Paint Condition After Wash
As you can see the paint was in rather poor condition, lots of swirls, rids and holograms.
The entire car looked this way.
Correction Process
This was my first test spot, which was Hyper Polish on an Orange LC Flat pad. The results looked pretty good however there were still a lot of RIDS left in the surface. I ended up finishing the vehicle with FG400 on Megs MF pads.
Before
After
The workhorses
Finished Pictures
After finishing the compounding the car was pulled out and quickly washed again, the sealed off with Hydr02.
Sun Shots
Interior Shots
Thanks for taking a look.
