Basic accesories for a PC 7424XPHi

L

lonye

New member
Joined
Sep 17, 2012
Messages
102
Reaction score
0
Hello Everybody

I'm new on detailing world. I've read lot of articles about PC and i'm buying one this week.
I'n going to use it on my car (It is a mid car, a Ford Fiesta).
Since I live in Argentina, and car care products are expensive
and there is not a huge variety, i'm planning to buy some products here.
I'd like to know what are escencial products I should buy together with my PC for a total car treatment.
I already have a Shampoo and Claybar kit (Mothers). I also apply Black Hole and some wax (Coll 915 and Naviwax).
What else should i have in order to make a full treatment (Wash-Clay-Polish-Seal/Wax).
Don't ask me why, but i've my mind set on klasse combo (AIO+High gloss sealant). I've seen cars with that combo and they were so glossy!


Thanks a lot for any advises!

Regards!
 
Is this the correct place for this post?
 
:welcome: To Autogeek Online!

A perfect match!


Here is some great information by Mike Phillips that will help you.


Paint Correction


Wolfgang Twins

First, remove moderate imperfections with Wolfgang Total Swirl Remover 3.0 and a light cutting pad. Then follow up with Wolfgang Finishing Glaze 3.0 and a gray finishing pad to smooth away haze and restore surface gloss. These two products are made to work hand in hand to give your vehicle a smooth, flawless shine in just two steps! Because they utilize fast-cutting nano abrasives, the polishes work well with an orbital or dual action polisher.

Menzerna Super Finish PO 106 FA

If there's one product I like that is strong enough to remove swirls and finish defects yet leaves the finish glass smooth and super glossy it Menzerna Super Finish (SF4000) PO 106 FA

Wipe On and Walk Away Sealants (Clear)


Traditional Sealants (Haze and Buff)


Wax



Foam Polishing Pads


Yellow Cutting 5.5 inch Foam Pad - Use this pad to apply compounds or polishes to remove severe oxidation, swirls, and scratches. It is the most aggressive and should only be used on oxidized and older finishes. Always follow this pad with an orange or white pad and a fine polish to refine the paint until it is smooth.

Orange Light Cutting 5.5 inch Foam Pad - Firm, high density foam for scratch and defect removal. Use this pad with polishes and swirl removers. It’s an all around pad that will work on most light to moderate imperfections.

White Polishing 5.5 inch Foam Pad - Less dense foam formula for the application of waxes, micro-fine polishes and sealants. This pad has very light cutting power so its perfect for pre-wax cleaners.

Gray Finishing 5.5 inch Foam Pad - Composition is firm enough to withstand added pressure during final finishing to remove buffer swirls. It has no cut and will apply thin, even coats of waxes, sealants, and glazes.
 
BobbyG said:
:welcome: To Autogeek Online!

A perfect match!

Here is some great information by Mike Phillips that will help you.



Paint Correction


Wolfgang Twins

First, remove moderate imperfections with Wolfgang Total Swirl Remover 3.0 and a light cutting pad. Then follow up with Wolfgang Finishing Glaze 3.0 and a gray finishing pad to smooth away haze and restore surface gloss. These two products are made to work hand in hand to give your vehicle a smooth, flawless shine in just two steps! Because they utilize fast-cutting nano abrasives, the polishes work well with an orbital or dual action polisher.

Menzerna Super Finish PO 106 FA

If there's one product I like that is strong enough to remove swirls and finish defects yet leaves the finish glass smooth and super glossy it Menzerna Super Finish (SF4000) PO 106 FA

Wipe On and Walk Away Sealants (Clear)


Traditional Sealants (Haze and Buff)

Wax


Foam Polishing Pads


Yellow Cutting 5.5 inch Foam Pad - Use this pad to apply compounds or polishes to remove severe oxidation, swirls, and scratches. It is the most aggressive and should only be used on oxidized and older finishes. Always follow this pad with an orange or white pad and a fine polish to refine the paint until it is smooth.

Orange Light Cutting 5.5 inch Foam Pad - Firm, high density foam for scratch and defect removal. Use this pad with polishes and swirl removers. It’s an all around pad that will work on most light to moderate imperfections.

White Polishing 5.5 inch Foam Pad - Less dense foam formula for the application of waxes, micro-fine polishes and sealants. This pad has very light cutting power so its perfect for pre-wax cleaners.

Gray Finishing 5.5 inch Foam Pad - Composition is firm enough to withstand added pressure during final finishing to remove buffer swirls. It has no cut and will apply thin, even coats of waxes, sealants, and glazes.
Click to expand...


Wowww that's really usefull! Thanks a Lot!
I'll choose all may products these days and i'let you know if I have any other doubt!

Again, thanks a lot!
 
You must log in or register to reply here.
Back
Top