Ceramic coating and humidity
- Thread starter Luket
- Start date
Desertnate
Well-known member
- Aug 5, 2013
- 6,216
- 268
From my experience flash times on some coatings will be much longer. At your temperatures it probably won't be too bad, but when cool AND damp, it really stretches things out.
Putting a space heater in your garage may just make it hot and humid rather than drying things out since you aren't removing the moisture from the air with a de-humidifier.
Honestly, I'd just press on as-is, be patient, and just adapt to what you see as the coating flashes and how it buffs out.
Putting a space heater in your garage may just make it hot and humid rather than drying things out since you aren't removing the moisture from the air with a de-humidifier.
Honestly, I'd just press on as-is, be patient, and just adapt to what you see as the coating flashes and how it buffs out.
Desertnate
Well-known member
- Aug 5, 2013
- 6,216
- 268
Ah, OK. I'd still expect it to haze slower and even then you might have to experiment to see the right amount of time wait before buffing.
With CQuartz in high humidity, not only does it flash slower, but you also have to wait a bit longer to keep it from smearing when you buff off. I always do a small test area each time to see how it is behaving that day and then adjust my timing and work flow from there.
With CQuartz in high humidity, not only does it flash slower, but you also have to wait a bit longer to keep it from smearing when you buff off. I always do a small test area each time to see how it is behaving that day and then adjust my timing and work flow from there.
The Guz
Well-known member
- Jun 17, 2013
- 8,777
- 57
Ain’t that the truth. People think black is hard to coat. I disagree.
Diffused lighting is your friend.
Desertnate
Well-known member
- Aug 5, 2013
- 6,216
- 268
The lighter the color, the harder it is to see the flashing or hazing. White and silver are probably the worst. The last time I did a sealant on a white car I had a terrible time seeing the hazing too and removal was a real bear because I couldn't see the spots I miss.
If you can't see real well, it's better to leave it a *bit* longer so you don't get any smearing. HOWEVER, don't leave it on so long you can't buff anything out without a lot of extra effort.
Dark colors and black are easy compared to white. White was the most difficult application I've ever done.
I might be a slow learner, but the diffused lighting really does make a difference. I only recently discovered working in a semi-dark environment and then reflecting my lights off the ceiling; a real game changer for me in coating application.