Foam cannon

[v1ru5879]

After reading on here all night I'm getting mixed answers for my question. My question is what cannon will work with my greenworks 1600 psi 1.2 gpm electric pressure washer. Some say yes some say no and some say there is a special one for electric washers. What's the best advice here?

Sent from my XT1080 using Tapatalk

 

[CaveRacing]

I have a Greenworks 1600 1.2, as well. Yes, there is a specific cannon for low pressure electrics (up to 2600 psi).

When you do a search, look for the MTM Foam Cannon 14.0349. You should find a couple of places that sell it for $60. It should come with the 1/4" male quick connect adapter that will connect directly to your wand.

There other MTM is the 14.0263. It is made for higher pressure (typically gas) pressure washers. This is the original one.

There IS a difference in performance, so I would get the 14.0349 so you have the proper one for your 1600psi machine. Mine works great!

 

[v1ru5879]

Thanks for the quick response! Now I can order away. I was almost thinking about getting a foam blaster for the garden hose after reading all the mixed answers last night. This definitely helps with my decision making

Sent from my XT1080 using Tapatalk

 

[v1ru5879]

I have a Greenworks 1600 1.2, as well. Yes, there is a specific cannon for low pressure electrics (up to 2600 psi).

When you do a search, look for the MTM Foam Cannon 14.0349. You should find a couple of places that sell it for $60. It should come with the 1/4" male quick connect adapter that will connect directly to your wand.

There other MTM is the 14.0263. It is made for higher pressure (typically gas) pressure washers. This is the original one.

There IS a difference in performance, so I would get the 14.0349 so you have the proper one for your 1600psi machine. Mine works great!

I found the lance you mentioned it has a bayonet attachment is this the attachment I should use or swap out for a quick connect?

Sent from my XT1080 using Tapatalk

 

[CaveRacing]

I found the lance you mentioned it has a bayonet attachment is this the attachment I should use or swap out for a quick connect?

Sent from my XT1080 using Tapatalk

It should come with both, but yes, you'll want to swap out for the 1/4" quick connect. The end of your wand should already be the female quick connect coupler. Screw the male quick connect adapter into the cannon (use some Teflon tape) and then you'll easily be able to swap between the spray tip and cannon at the end of your pressure washer wand.