LC backing plate question

[emmjay]

Hello all,

I've been looking at the changeable backing plate system from LC and I have ordered it. I've seen posts about the shims and the problems with the 6" that were rectified and detailed instructions on how to install on this forum. However, I have not seen any instructions about assembling the 4" plate. From what I understand:

Step 1: Remove the stock BP, washer and bolt and set aside.
Step 2: Take the 4" plate, gear, SUPPLIED bolt and washer and assemble.

Is this correct? So for the 4" plate I use the supplied bolt and washer and not the stock one that came with the flex?

Thank you

 

[dlc95]

You should be fine with the supplied bolt.

Check out this video from the guys at Lake Country.

[ame="http://m.youtube.com/watch?v=jQEGQZpua7Q"]Lake Country Flex XC 3401 VRG Backing Plate System - YouTube[/video]

 

[Kamakaz1961]

I have no issues with this system. You should be fine and the Lake Country Video is perfect!!

 

[emmjay]

Yeah I watched that video twice just to make sure

That's good to hear. I was just weary about which screw/washer to use.

Thanks guys :dblthumb2: