Need to Test an UDM for Vibration

M

MrAP

New member
Joined
Jul 17, 2007
Messages
5
Reaction score
0
I would be very grateful if anyone has an UDM (and/or a Festool or something else) and would be willing to let me test it (I can come over or we can meet somewhere) so I can figure out exactly how much vibration is generated.

I have some neck issues, so it is very important for me to find out, so I'm not stuck with a $200 tool! I intend to use it to just apply and remove sealants, although I might wind up using it for minor swirl corrections too.

I am in the South Florida area around West Palm Beach, and PB or Broward is in decent reach for me. Would really prefer to avoid Miami-Dade if at all possible :)

Thanks!
AP
 
Last edited:
sorry dude, I wouldn't mind letting you try my UDM out, but I'm in CA, not so close to FL... just to let you know, it does vibrate a lot in my opinion. Its something you'll have to get use to I guess as you work w/ that tool.
 
When the UDM first came out, I seem to remember several people comparing it to the PC which was described as a machine that vibrates quite a bit. They had said the UDM had much less vibration then the PC. Is the vibration being discussed in the UDM something that has developed over time or something that was noticed when the machine was brand new?
 
I have a UDM but not a PC, so I can't compare. MrAP, I would let you try it out but I live in California :(.
 
You must log in or register to reply here.
Back
Top