Colinate 845 ?

[mikesal57]

After the process to get it to liquid form..
Does it revert back to the clump?

mike

[van185]

Yes it probaby will. I have several bottles and some are clumped and some are liquid. The best way I've found is to heat it up and shake and then shake some more and then shake some more. Wonderful wax none the less.

[mikesal57]

Yes it probaby will. I have several bottles and some are clumped and some are liquid. The best way I've found is to heat it up and shake and then shake some more and then shake some more. Wonderful wax none the less.


thxs Van

[damaged442]

x2 what van said. It depends on ambient temperature. From my experience, as it cools, it clumps. Warm it up, shake it and you are good to go.

[wdmaccord]

Yep, once it re-cools it goes back to being clumpy. Just reheat it in the sun or a sink bath of hot water. Just remember to shake it multiple times when you are reliquifying it. I put a few ounces in a Megs clean top applicator bottle. That way I am only heating up a few ounces at a time and not heating and cooling the entire bottle over and over.

[Sicoupe]

Can I just use this as my LSP only? Thanks in advance.

[jamesboyy]

[QUOTE=Sicoupe;967227]Can I just use this as my LSP only? Thanks in advance.[/QUOTE

yes you can use colinate 845 as your only LSP if you want

[Sicoupe]

^ thanks for your help:)

[Bill1234]

You have a couple of options to get it more of a liquid
wack it on a good table and shake it
leave the wax in the bottle and put it in a bucket with hot water

[dorkiedoode]

Mine stay in liquid form after. It might look like its solid but with one shake it turn into liquid.

[Klasse Act]

Can I just use this as my LSP only? Thanks in advance.

What else would you use it for?

Sent from my SPH-M930 using AG Online

[jjj]

Great on wheels too.

[shoboy]

Been using it for quite some time, very good beading properties and it lasted for months (as long as you have prep your paint).

[Jaretr1]

I have just placed the bottle in the sun while I was washing the car, that usually got it to a perfect liquid consistency. It does leave a nice shine, so no reason to top it. Its durability is excellent. I have used it on wheels as well. Just apply it very thin, it does not like being over applied.

[Desertnate]

I have just placed the bottle in the sun while I was washing the car, that usually got it to a perfect liquid consistency.

It may depend on the ambient temperature, but I found when leaving it in the sun this weekend I was still left with really small chunks I could see on the buffer pad. I had to give it a hard shake for about 30 seconds in order to minimize the chunk size. At the time the temp was around 70F.