Buffing with the edge of the pad?

[VincenzaV]

Hi, I hope this question is in the correct section. I am going to restore the headlights on a 2010 Prius. This particular car's headlight shape is complicated. Instead of removing the front bumper cover, I was hoping I could use the edge of the wool or foam pad to cut the deteriorated surface? I ordered 3" pads, however the backing plate is 3" and the pads are 4.25"-4.75"

I wish they made smaller for those really tight spots doing headlights.

 

[FUNX650]

Here's an edgy article, where several
small pads are also being showcased:

http://www.autogeekonline.net/forum...illips/92794-how-polish-thin-body-panels.html

Bob

 

[Mantilgh]

Tape off the surrounding paint well and machine polish what you can. Sometimes you just have to do the tight areas by hand unless you pull them out.

I wish they made smaller for those really tight spots doing headlights.

Here are some smaller ones that will work with your drill:

FLEX PE8 Rotary Foam Pads 1, 2, 3 Inch Diameter

FLEX Rotary Backing Plates 1, 2, 3 Inch Diameter

Spot Buffs Drill Adapter

 

[VincenzaV]

OMG-Thank you Funx650! I had no idea that small of a pad exists (I'm sure overspending the pad can be a real concern due to the smaller cir.)

Mantilgh-Great point. I didn't think really about using hand to compliment the majority done with the machine. Thank you for the suggestions too! I'm definitely getting some to have a complete arsenal!