BOSS 21 or Rupes 21 MkII

[UTdetailing]

Guess I'll throw my question in here........ I use a Rotary for serious correction and a GG6 for finishing, and am pondering this long throw stuff. My outlying question is, what does the 6MM of additional throw offer on a 5.5" pad? Not an engineer so dumb it down for me hahaha.

 

[Joel1979]

Guess I'll throw my question in here........ I use a Rotary for serious correction and a GG6 for finishing, and am pondering this long throw stuff. My outlying question is, what does the 6MM of additional throw offer on a 5.5" pad? Not an engineer so dumb it down for me hahaha.

Most agressive cut youll get is 21 Boss or MK2 with 5"bp. That combo also creates lots of heat so be careful with your pads, especially microfiber pads. Center hole helps.

 

[Ceerokz]

Guess I'll throw my question in here........ I use a Rotary for serious correction and a GG6 for finishing, and am pondering this long throw stuff. My outlying question is, what does the 6MM of additional throw offer on a 5.5" pad? Not an engineer so dumb it down for me hahaha.

The gg6 paired with the 5 inch pads is awesome. Easier to control. I actually like the fat pads. When I use it with the Boss thin pads I tend to rotate more frequent.