Side bar for GG?

slickooz

slickooz

New member
Joined
Nov 8, 2010
Messages
2,657
Reaction score
0
I used a Dewalt rotary buffer before and really liked the side arm handle. I wanted to know if there something I can buy to use, don't really like the bridge type handle bar.
 
slickooz said:
I used a Dewalt rotary buffer before and really liked the side arm handle. I wanted to know if there something I can buy to use, don't really like the bridge type handle bar.
Click to expand...

Talk to some of the people here. A lot of people don't use their PC handles. I don't use a handle on my GG DA either. One of them might trade you for something or give it to ya if you pay the shipping.
 
Thanks, do you think it will screw in? same size?
 
I would think so. I'm pretty sure that the GG DA is just a rebranded PC, but I could be wrong. Ask Mike
 
dont use the handle at all just center my hand on the machine and go to work
 
Also just use my hand not the handle. IMO the handle just gets in the way.
 
Going try no handle method. That handle takes up too much room.
 
IOMCAMARO said:
I would think so. I'm pretty sure that the GG DA is just a rebranded PC, but I could be wrong. Ask Mike
Click to expand...

Just to back up what Dwayne posted, the Griot's Garage is not a re-branded Porter Cable.

slickooz said:
Going try no handle method. That handle takes up too much room.
Click to expand...

Most people after trying the DA polisher without the handle will pitch the handle and never look back.

With the Porter Cable units the plastic housing over the head will vibrate and slide off if you're using it without the handle. The design is such that the handle holds the plastic housing onto the head of the unit, remove the handle and the housing will come off.

One way to fix this is for the Porter Cable models is with some duct tape the other way is to simply bold the plastic on with two Hex Head Bolts and a couple flat washers.

Here's a how to article on this...

PC Modification For Use Without The Handle


With the Griot's Garage and Meguiar's DA Polishers, you can remove the Bail Handle if you like and the plastic housing over the head will stay in place as there are tabs built into the inside of the plastic housing that prevents the plastic housing from sliding off.


:)
 
You must log in or register to reply here.
Back
Top