After compounding...

TheGuyWho

TheGuyWho

New member
Joined
Feb 9, 2011
Messages
81
Reaction score
0
This might seem like a ridiculous question to some people, but after using Megs UC, do you have to follow it up with polish or something else or could I just use wax to seal it and be done? Reason I ask is I just started on my wife's Expedition today for a much needed detail. I thought I had neglected it pretty bad, but once I washed and clayed it it didn't seem all that bad at all. As of right now ive done Megs UC on the whole thing, and to be honest it doesn't look bad. Its silver, so it hides scratches and swirls extremely well. And the scratches/swirls that are visible (to me) aren't even that bad. In act Im not even sure I could get them out with foam pads to begin with.

Whats the consensus? Absolutely follow with polish, or can I just go to wax?

Im using a Meguiars DA polisher. I have Megs 105 and swirl remover 2.0 in my arsenal I could use.
 
m105 is very agressive with a cutting pad. I would start with the swirl remover. If that does not work, step it up to uc. Are you using light pressure and speed 4-5. A cross hatch pattern with 4 passes should remove most
 
Yes I know its aggressive. Im not necessarily looking for advice on getting rid of swirls. I know how to do that. Im saying the swirls that are there, if you can find them, don't bother me. So can I just seal it or should I, or do I NEED to follow UC with a polish?
 
You don't need to follow it with polish. In fact the less polishing you do on it the better off you are. Wax it..
 
tuscarora dave said:
If it looks good to you...go straight to wax.
Click to expand...

Thanks. Im just being lazy on this one. Its a dirty old 4x4, that looks pretty damn good for a dirty old 4x4. Hahaha, the silver color hides just about everything to the naked eye. Its a great color for the wife's car… Hahaha :dblthumb2:
 
I like to use UP, does a real good job for a consumer line product. I can't lie though m205 is on my next order.
 
Since Meg's UC uses SMAT abrasives technology...
You can stop/finish polishing anywhere in the buffing-cycle
without leaving swirls caused by the abrasives.

So if your happy with the way the vehicle's paint looks after finishing using UC...
By all means: Apply your LSP.

:)

Bob
 
You must log in or register to reply here.
Back
Top