Buff and Shine Microfiber Pads - Seeking Feedback

[Zelfiris]

Hi Everyone,

Has anyone tried them? Comments? These are fairly new so I haven't found much feedback. This is my first time jumping to microfiber polishing pads from LC CCS foam pads.

I will be using them early next week with my brand new Rupees 15ES I just received a set of them and they look like quality pads. Any particular speed I should be running? I'm concern with the feedback of early batches of Meg's MF pads coming apart. I don't want to run at speed 6 and the pads immediately rip in half from one use.

I appreciate any comments!

 

[ski2]

Haven't tried them yet, but here is a comment from someone who has on another forum: "cuts a bit less than the megs, but its smoother, last longer, runs cooler, and you can literally use one pad on an entire car!"

 

[Zelfiris]

Haven't tried them yet, but here is a comment from someone who has on another forum: "cuts a bit less than the megs, but its smoother, last longer, runs cooler, and you can literally use one pad on an entire car!"

thanks for finding the info for me ski2!

 

[Old Tiger]

I would use Speed 4 same as Megs recommends. If you bought the finishing pads too, drop to speed 3 and back off the pressure.

 

[RhetoricMixes]

I used the 4 inch finishing microfiber pads this weekend on two beauties. Seemed to work very well. Also was my first time using MF pads to boot!

 

[sproketser]

Nice rides in there , great work .

 

[Zelfiris]

I would use Speed 4 same as Megs recommends. If you bought the finishing pads too, drop to speed 3 and back off the pressure.

thanks tiger, I will try that first

I used the 4 inch finishing microfiber pads this weekend on two beauties. Seemed to work very well. Also was my first time using MF pads to boot!

very nice rides!