Thanks. Seems as though I might need less and work it longer 'til it flashes. I'll just keep playing with it. After looking at the car in the sun today I'll need to work out some of the halograms:)
Sorry for the "Pinnacle" post. Haven't done much of this and was just happy to get my...
How long is the working time of of Menz Power Finish? I used it for the first time today and could use some help. I was using a Megs tan finishing pad on a Makita rotary. Loaded the pad to start and then used three or four small pea size thereafter for each 2x2 square and a water mist at...
You're not kidding it's hard for the first timer!! I'll get it yet though. :D Do you completely load up the pad with product at the onset or do you put a little bit on pad and use product line on panel and pick up as you start? Or a better way to put it 'How do you start off using 105 on a...
I won a makita $150 and a Vector rotary $25 on on ebay in the same week. Both unused. Haven't used the Vector yet, but a friend also bought one new $75+ for his boat and seemed to like it. It seemed to have good reviews. Not sure where it was that I read them though. Sorry
Sorry I didn't put a little smiley face at the end of my facetious comment about the "steering defect" inherent to Vipers. We all know what the obvious defect is.....
:D:welcome::goodpost:Im the MANIm the MAN:D:cheers::DIm the MAN
...the tires don't hold enough air:D
work for a fire department and have seen one wrapped around a pole and another in the front of a house. The one in the house was bought that day and he had his six year old in the front seat. Apparently there needs to be a recall on Vipers to fix the steering defect!!!
While using megs 105 and megs maroon pad @ 900-1300rpm rotary I seem to keep getting "gummed up" spots. These spots will not buff down until I go over it again with more product. WHY??? I use about quarter size on the pad with occasional QD. Temp around here these days runs 50-60 degrees if...
I have and used a Makita rotary for the first time. Used Megs swirl remover #9 with white Megs pad as final polishing step. Some very faint swirls still seen in bright sun at an angle. Can I get a completely swirl free finish with rotary or would it be best to do final polishing with DA?
Thanks
Have barely noticeable swirls on black after Megs #1 on Megs maroon pad and then Megs#9 on white pad applied with rotary. What next to get rid of swirls either by hand or rotary applied??
Detailed cars 20yrs ago which at that time consisted of washing, windows and waxing. No paint correction. Thought it was time to play around with detailing again. Bought a Makita a few weeks ago as I read this was the way to fix paint rather than cover up blemishes with DA. Went to local...
Hello,
Anyone know if the Central Pneum. orbitals (such as the ones listed at HarborFreight.com) can be fitted with the velcro backer plate and used the same as a PC?
Has anyone used pneumatics for detailing? I'm wondering if the air exhaust/oil mix messes up progress!
Thanks
Chances are it still might sting a bit to get hit by any of those washed up no skill drunks!! I'd rather just sit in my recliner and watch them smash each other!